58 Finometer® Model-2 User’s Guide
Where “PPPPPP” can be : FMS or OHMEDA
PHYSIOCAL or HEIGHT is
tween FMS or OHMEDA.
When a protocol is selected and a measurement is started the serial
ort will use the selected protocol.
he pressure recon
protocol. T ressure reconstruction level
is selected automa fic serial protocol is chosen in the
configuratio u is from disk during
system boot.
Pressure reconstruction level
By default the FMS protocol is selected. Each time
pressed, the protocol toggles be
p
Note : BeatScope® Easy uses the FMS protocol.
T struction level depends on the chosen serial
ing table shows which phe follow
tically when a speci
n men and when the setting loaded
Serial protocol
after system boot
FMS BRA
OHMEDA FIN
When the system is running and the serial protocol is changed fro
OHMEDA back to FMS, t
m
he pressure reconstruction level will stay at the
nger level indicated by FIN.
e serial
uration, the system will go back into ready mode and the
configuration is saved.
When the MARKER key is pressed, the configuration menu will show the
next configuration item, being the software version display option.
5.
When the software version display option is started (see Table 4.1,
fi
When the START/STOP key is pressed at any time during th
protocol config
4.5 Software version
Physiocal
SERIAL PROTOCOL
Prot
Systolic Diastolic Mean Rate (bpm)
Height (mmHg)
ocol: PPPPPP
To Next Page
Loading...
