FINAPRES Finometer Model-2 - Analog Signal Input; Calibration Options; Analog Output Calibration

54 Finometer® Model-2 User’s Guide
Note2: In BeatScope® Easy v01.02build002 the default output
4 is the Marker signal. This can be changed to
l provided on the
external input.
5.2.2 na nal inpu
One BNC connector is available on the I/O unit, to input an external
signal in inometer n
-5V and + 5V and will be with the
blood pressure waveform
5.3 Calibration option
5.3.1 Analog output cal
Finometer® Model-2 gen tern on its analog
corder or other recording system.
of
4 of the
Plethysmogram or to the signa
A log sig t
to the F ® Model-2. This signal must range betwee
sampled and stored simultaneously
samples.
s
ibration
erates a calibration pat
outputs to calibrate a stripchart re
With this signal the dynamic response, polarity and sensitivity
) recording channels can be calibrated and tested. subsequent (external
The calibration signal is available when the Finometer® Model-2 is in
Ready Mode. The calibration signal is available only for output 1, 2 and
I/O unit, when Finometer® Model-2 is used stand-alone.