Finometer® Model-2 User’s Guide 67
Upon pressing the
changes to:
ote: It is recommended to use a logbook during a measurement to
note the ti the
MARKER key. Only
usable in combina nit and/or
BeatScope y
ote: When BeatScope® Easy is used to set a marker, it is possible to
6.
f
ressure controller can be checked by pressing the
HEIGHT key. The
display will show the following, for a small period of time:
The top line shows the state of the internal servo system. The upper
right corner shows information on the internal status of Finometer®
Model-2, not relevant to the user. The lower line shows the DC
(V=NNN) and pulsatile (V:NNN) components of the plethysmogram
observed during the last Physiocal and the gain (GNNNN) of the servo
controller in arbitrary units.
6.5 Run time messages
Run time messages occur during Run mode. These messages refer to
the contraction state of the finger arteries. Below is an example of a run
time message during a measurement:
MARKER button the LCD display
N
me and the reason for pressing
tion with the Analog I/O u
® Eas .
N
enter a corresponding note immediately.
4.3 Checking run time information
During a measurement the status of the plethysmograph and cuf
p
Physiocal Height
STATE .LOG
V=NNNV:NNN GNNNN
Systolic Diastolic Mean Rate (bpm)
Physiocal Height
SSS:DDD:MMM:RRR:
Systolic Diastolic Mean Rate (bpm)
MARKER PRESSED
To Next Page
Loading...