68 Finometer® Model-2 User’s Guide
he run time messages are defined in the following table (Table 6.2 Run
T
time messages).
Physiocal Height
Message Description
CONTR s observed, probably due to cold
hands:
CTED ARTERY No plethysmogram i
• Warm the hand and the arm proximal of the cuff.
• Try another finger.
LOW PLETHYSM Pulsatile component (V:) of plethysmogram is too
he arm proximal of the cuff.
• Try another finger.
small:
• Warm the hand and t
Table 6.2 Run time messages
6.6 Stopping
Upon completion of the m ed as follows:
Press the
START/STOP key to stop the measurement.
6.
To start a Finometer® Model-2 recording on a PC:
1. Connect the serial cable between main unit and a serial port in the
PC.
col is configured, see 5.4.4.
a measurement
easurement, it is stopp
1.
2. Disconnect the cuff air hoses from the Frontend Unit to protect the
finger cuffs from accidental inflation.
3. Unwrap and remove the finger cuffs and take the Frontend Unit
away from the subject.
7 Data on a PC
2. Run the BeatScope® Easy PC software.
3. Refer to the BeatScope® Easy User’s Guide for further information.
4. Make sure that the FMS serial proto
SSS!DDD!MMM!RRR!
LOW PLETHYSM
Systolic Diastolic Mean Rate (bpm)
To Next Page
Loading...
