66 Finometer® Model-2 User’s Guide
Physiocal Height
here ‘22’ is the number of beats to the next Physiocal. With Physiocal
swi hed off, the number of beats change to a blinking ‘OFF’:
Phy
physiology. It is an 5 to 10 min, with
the Physiocal function sw some pressure drift may
result, if finger physiolog riod. When Physiocal is
switched off for m i ed by the
buzz r (if the buzzer is on, see 5.4.3). These beeps will be k pt
gen
6.4.2
To generate an event marker press the MARKER button on the main unit
(see Figure 6.4). After pressing the
MARKER button, it will become
available on output channel 4 of the I/O unit.
w
tc
siocal should normally be “ON” to follow any changes in finger
advised not to measure longer th
itched “OFF”, because
y is not stable in this pe
an 2 minutes, 2 beeps wore th ll be generat
e e
erated every 2 minutes until Physiocal is switched on again.
Marking events
Figure 6.4 The 4 keys keypad
Physiocal Height
SSS:DDD:MMM:RRR:
OFF BRA C1 +02
Systolic Diastolic Mean Rate (bpm)
SSS:DDD:MMM:RRR:
22 BRA C1 +02
Systolic Diastolic Mean Rate (bpm)
To Next Page
Loading...
