FINAPRES Finometer Model-2 - Checking Height Correction Unit Nulling; Performing a Height Correction Unit Nulling Procedure

Finometer® Model-2 User’s Guide 49
rrent Height Correction Unit nulling:
d reference point of
5. ng a Height Correction Unit nulling procedure
. The Finometer® Model-2 should be in Ready mode.
of
the
HEIGHT key to start the procedure.
After about a second the following message should be displayed:
. The height value will be updated continuously.
. Press the
START/STOP key to return to Ready mode.
5.1.1 Checking Height Correction Unit nulling
To check the cu
1. Keep the Height Correction Unit transducer an
the Height Correction Unit at the same level (Figure 5.1 Checking
the Height Correction Unit nulling).
Figure 5.1 Checking the Height Correction Unit nulling
2. Check the height value that is displayed in Ready mode on the LCD
display. This value should be ‘00’. Perform a Height Correction Unit
nulling procedure if this value is not ‘00’.
.2 Performi1
To perform a Height Correction Unit nulling procedure:
1
2. Keep the Height Correction Unit transducer and reference point
the Height Correction Unit at the same level (Figure 5.1 Checking
the Height Correction Unit nulling).
3. Press
4
5
Physiocal Height
Heig
Systolic Diastolic Mean Rate (bpm)
ht Null:STOP
OKAY HEIGHT+HHH