Finometer® Model-2 User’s Guide 59
Finometer Model-2 w to enter this mode) the
following will be dis
he display will be frozen until the next option in the menu is chosen or
hen the START/STOP key is pressed at any time during the software
and
ill
configuration item again, being the steady pressure
alibration check.
5.5 PC monitoring and recording with BeatScope® Easy
nd
through the serial line or through a USB
al converter to connect to the device’s serial port, e.g. the FTDI
or
software provides this monitoring and recording
y in addition to control the most important functions of the
waveform and beat-to-beat data in
real-time:
from the main unit serial port connector -
indicated with the ‘RS-232’ label - to an unused serial port on a PC.
control key functions ho
played:
S
See paragraph 4.2.1 for an explanation of the format of the software
version.
T
until the menu is left.
W
version display option, the system will go back into Ready mode
the configuration is saved.
When the MARKER key is pressed, the “Configuration option menu” w
show the first
c
It is possible to monitor and record the pressure waveform and tre
of the beat-to-beat derived parameters in real-time, when Finometer®
Model-2 is connected to a PC
to seri
US232-R-100 cable. Install the correct driver to connect to COM1
COM2. See also: Installation Guide USB/RS232 converter.
The BeatScope® Easy
capabilit
Finometer® Model-2 device from PC.
To monitor and record the pressure
1. Connect a serial cable
2. Run BeatScope® Easy.
Physiocal Height
Software version
v02.10 build 004
ystolic Diastolic Mean Rate (bpm)
To Next Page
Loading...