Finometer® Model-2 User’s Guide 55
Figure 5.3 Calibration signal specification
Other c
see 5.4.
Note: In ready annel 3 of the I/O box will generate
the applied signal of the ECG input at the front of Finometer®
Model-2.
5.4
T be activated by pressing the
MARKER and PHYSIOCAL key simultaneously while the system is in ready
mode. The first available procedure is the steady pressure check.
Whe
ed, the “Configuration Option Menu”
procedure will show the next option, being the “Pressure waveform
calibration output”. Hereafter the “Beeper”, “Serial protocol” and finally
e chosen, respectively. When the
MARKER ar “Configuration Option Menu”
w art again with the steady pressure check.
W
e
s
t
o the internal storage as defaults, remaining valid when the device is
s
5.4
When the steady pressure check is started (see Table 4.1 Finometer®
Model-2 control key functions, how to enter this mode) the following
will be displayed:
“G” stands for generated pressure, “M” stands for measured pressure.
“NNN” can be any numerical value between 0 and 250 in units of
alibration options can be found in the configuration option menu
1 and 5.4.2.
mode, output ch
Configuration option menu
he “Configuration Option Menu” can
n the
MARKER key is press
the “Software version” options can b
key is pressed again, the circul
ill st
hen the
START/STOP key is pressed at any time, the chosen settings ar
aved and the system goes back into Ready mode. Saved means that
he configuration parameters for beeper and serial protocol are stored
n
witched on again after power off.
.1 Steady pressure calibration check
Physiocal Height
STEADY PRESSURE
G:NNN M:NNN mmHg
Systolic Diastolic Mean Rate (bpm)
To Next Page
Loading...
