FINAPRES Finometer Model-2 - Measurement Options; Switching Physiocal ON;OFF

Finometer® Model-2 User’s Guide 65
s urrent DC level (V=NNN) and pulsatile AC (V:NNN)
components of the plethysmogram in arbitrary, but compatible
units(N=0…9), and cuff pressure (p=NNN) in mmHg for each
meter®
g.:
where the labels on the front panel around the display correspond
isplayed beat-to-beat values.
6.4
T cribes the available functions while in Run mode.
6. hysiocal ON/OFF
During Run mode the pressure waveform is interrupted for two or more
plet ysmogram and the physiological state of the finger. This Physiocal
procedure can be switched off and on by pressing the
PHYSIOCAL key.
ed
information about this option.
y ,
e.g
howing the c
pressure level during the pressure staircase procedure.
• After performing the pressure staircase at start-up, Fino
Model-2 starts displaying beat-to-beat values in Run mode, e.
with the nearest d
See section 6.7 for more information about the beat-to-beat display
during Run mode.
Measurement options
his section des
4.1 Switching P
beats at intervals determined by the software to observe the
h
Refer to the Finger Pressure Reference Guide for more detail
Ph siocal status information is given on the lower line of the display
.:
Physiocal Height
SSS:DDD:MMM:RRR:
C1 +HHH
Systolic Diastolic Mean Rate (bpm)
PP BRA
Physiocal Height
START PROCEDURE
V=NNNV:NNN p=NNN
Systolic Diastolic Mean Rate (bpm)