Finometer® Model-2 User’s Guide 89
The sed emissions or decreased
immunity of the Finometer® Model-2.
Th ould not ent to or stacked
with other equipment and that if ad
the should be ify normal operation
in the configuration in which it will be used.
Electromagnetic emissions
I netic emission 1, table 201)
is used
in such
non-observance may result in increa
e Finometer® Model-2 sh be used adjac
jacent or stacked use is necessary,
Finometer® Model-2 observed to ver
nformation reference: electromag s (IEC 60601-1-2:200
The Finometer® Model-2 is intended for use in the electromagnetic environment specified
below. The customer or the user of the Finometer® Model-2 should assure that it
an environment.
Emissions test Compliance Electromagnetic environment -
guidance
RF
CISPR 11
The Finometer® Model-2 uses RF
energy only for its internal function.
Therefore, its RF emissions are very
ly to cause any
emissions
Group 1
low and are not like
interference in nearby electronic
equipment.
RF emissions
CISPR 11
Class A
Harmonic emissions
IEC 61000-3-2 Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies
The Finometer® Model-2 is suitable
for use in all establishments other
twork that supplies
buildings used for domestic purpose.
than domestic and those directly
connected to the public low-voltage
power supply ne
To Next Page
Loading...
