92 Finometer® Model-2 User’s Guide
commended separation distance between
portable and m un uipm
r®
Re
obile RF comm
Finomete
ications eq
Model-2
ent and the
The Finometer® Model-2 is intended for use in the e ctromagnetic
disturbances are controlled. The customer or the user of th Finome
electromagnetic interference by maintaining a minimum di ance be
communication equipment (tran mitters) and the Finome r® Mod
according to the maximum output power of the communications eq
le environment in which radiated RF
ter® Model-2 can help prevent
tween portable and mobile RF
el-2 as recommended below,
uipment.
e
st
s s te
S paration distance acco ng to
m
e rdi frequency of transmitter
Rated maxi
output power of
transmitt
W
0 k 0 MHz
d = 1, √P
80 800
2 √
z to 2,5 GHz
mum
er
15 Hz to 8
2
MHz to MHz
800 MH
d = 1, P
d = 2,3 √P
0,01 0, 0,12 12 0,23
0,1 0,38 0,38 0,73
1 1,2 1,2 2,3
10 3,8 3,8 7,3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separati
distance d in metres (m) can be estimated using the equation appli e
transmitter, where P is the maximum output power rating of the tra
to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the ange applies.
NOTE 2 These guidelines may not apply in all situation. Electroma
absorption and reflection from structures, objects and pe
on
cable to the frequency of th
nsmitter in watts (W) according
higher frequency r
gnetic propagation is affected by
ople.
Information reference: electromagnetic emissions (IEC 60601-1-2:2001, table 206)
To Next Page
Loading...
