VIEW-LOG-PARAMETERS
Read through the following section carefully to get an
overall view of how to use the Programming for the Us
-
ers. For details regarding the parameters of each
phase, refer to the respective paragraph in the “PRO
-
GRAMMING FROM A PC” chapter of the Installation
Manual.
From the Main Page, the User can manage without Ac
-
cess code:
Ø
View parameters (Use 1=ANALYZE)
Ø
View Log (Use 3= View LOG or 1=ANALYZE and
then use 8 Key)
Ø
View Lists (Use 4= MORE and then 2)
and with User Access code can manage this menu:
Ø
Modify
Ø
Disable
n View parameters
Figure 17 shows how to manage the viewing of different
parameters:
In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to select the different viewing functions:
1= Loop: start the procedure for selection and viewing
of the loop data;
2= To activate the selection and visualization sequence
of the loop devices real time data;
3 = SW zone: activates the selection and display proce
-
dure for the data corresponding to all SW zones;
4 = Output: activates the selection and viewing proce
-
dure for the data corresponding to an output;
5= Network: start the procedure for viewing of all de
-
vices (Repeaters and MFI module) on the RS485 Net
-
work;
6 = Communic: activates the viewing sequence for all
communication units main data;
7 = Option: activates the viewing sequence for all lo-
cally programmed system options;
8= Log: start the procedure for viewing of Logged
events;
9= Fw ver.: start the procedure for viewing of FW ver-
sion of all processors in the panel;
0= Panel: start the procedure for viewing Panel
informations.
Cursor keys No function is related to the UP,Down,
Right and Left key.
ESC Key Use the ESC key to step back to MAIN page.
ENTER Key No function is related to the ENTER key.
VIEW-LOG-PARAMETERS 15
To Next Page
Loading...
