FireClass FC501-L - Key - COMMUNIC. (Disable); Select the COMMUNIC. Device; Disable COMMUNIC. Device

ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER Key Use the ENTER Key to confirm. The User
Interface moves to the MAIN page followed by a panel
reset.
6 Key - COMMUNIC. (Disable)
The 6 Key is used to select the Disable Communic. de
-
vices option; after Communic. device has been se
-
lected, will be disable/enable; the corresponding
Telecom module will then be disabled/enabled accord
-
ingly.
n
Select the COMMUNIC. device
In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to select the identification number of module.
+
If the number is incorrect, an error message will be
shown: NO ACTION TO BE DONE
Cursor Keys Use the UP Key to show the next type of
Telecom module.
Use the Down Key to show the previous type of
Telecom module.
The type of Telecom module are:
- TEL i/f
- Alarm TX
- Fault TX
-IPi/f
- Alarm IP
- Fault IP
No function is related to the Right Key;
No function is related to the Left Key.
ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER Key Use the ENTER key to confirm and dis
-
play the next page.
n
Disable COMMUNIC. device
In this phase: the display shows the current status, the
possible actions are: ENABLE or DISABLE.
Alphanumeric keypad No function is related to Al
-
phanumeric keypad.
Cursor Keys No function is related to the UP, Down,
Right and Left Keys.
ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER Key Use the ENTER Key to confirm. The User
Interface moves to the MAIN page followed by a panel
reset.
+
If a module is disabled (TEL i/if or TX Alarms or TX
Fault or IP Alarm or IP Fault), the Disabled indica
-
tor light will glow, as will the yellow Communicator
indicator light.
+
If the TEL i/f communicator has not been enabled us
-
ing software (Options page- FireClass Console ) and
you attempt to enable/disable it, the following text will
appear on the display: NO ACTION TO BE DONE
DISABLE 31
FC501 panel lev.2 : DISABLE
Repeater: 001
FC501 panel lev.2 : DISABLE
Repeater: 001 Label
Disabled?
ENABLED
Actual Status
Device
Dis./Enable
Request Enable/Disable
Up or Down to select the type
Enter the Repeater number
If it blinks the panel
is operating normally
Control Panel name
Access Level
Control panel
Status
Device name
Identification number
Control Panel name
Access Level
Control panel
Status
Figure 42 Display Disable/enable Network device.
FC501 Panel lev.2 : DISABLE
TEL i/f
Communicator Type
FC501 Panel lev.2 : DISABLE
TEL i/f
Disabled it?
ENABLED
Present status
Communicator
Dis./Enable
Request Enabled/Disabled
UP or Down per to select the type
If it blinks the panel
is operating normally
Control Panel name
Access Level
Control panel
Status
Figure 43 Display Enabled/Disabled Telecom (Com
-
municator.