FireClass FC501-L - Detailed Device Data on Loop

n
View device data on the Loop
Select the Loop and then the device, the Display will
show Figure 20.
In this phase:
Alphanumeric keypad No function is related to the Al
-
phanumeric keypad except 0 key to disable the device
(detector or module), it will require the entry of the ac
-
cess code if the access level is less than 2.
+
NOTE: This feature does not work in the case of
multichannel module not answering to loop poll.
Cursor Keys The UP Key, in the case of modules with
several inputs or outputs, can scroll through them;
The Down Key in the case of modules with several in
-
puts or outputs, can scroll through them;
the Right Key: displays the status of the next device on
the same loop; the Left Key: displays the status of the
previous device on the same loop; in the case of mod
-
ules with several inputs or outputs, this means it is pos
-
sible to scroll through them.
ESC Key Use the ESC key to cancel the operation and
to step back to previous page.
ENTER key No function is related to the ENTER key.
The Device status field displays the current status of the
detector or module, the possible values are:
-WORKING
-ACTIVE
-WARNING
-FAULT
-ZONE DIS.
-WALK TEST
-STAND-BY.
The device coordinate field displays:
-the loop ID,
-the device address,
-the device type,
-the channel ID (for the modules).
The “Device channels info area” displays:
-the channel ID S=Smoke, T=temperature, C=Carbon
monoxide (for the detector),
-the current analog value in percentage,
-a real time, pseudo-graphic representation of the cur
-
rent analog value with threshold,
-the channel configuration mode or the threshold value
-the channel status.
+
The device information is displayed only in the
case of devices in WORKING state.
VIEW-LOG-PARAMETERS 17
Office Zone stat: WORKING
Add:163 Type:801PH s=07% ----|--t=60%
T=26% ---|-A2S
Device name
Address
Sizes value
tested by detector
Function
mode
Type
Threshold
FC501 panel lev.1 : ANALYZE
Master Control panel
[L1] L2
List of the
present Loop
Loop 1
Name of the
selected Loop
FC501 panel lev.1: ANALYZE
Master control Panel
D001 [d187] m250 801PH
Inserted
address
List of the
present
devices
Loop 1
Name of the
selected Loop
Add= > 123 <
Selected device
type
Selected
device
This symbol shows the
device
presence
Control panel name
Access level
Control panel status
if it blinks the panel
is operating normally
Choose Loop
Initial of the selected
Loop
Label of
Control panel
Control panel name
Access level
Control panel status
Name of the
Control panel
Device status
Pattern of the
current value and
Threshold (if applicable)
IN THE DETECTOR CASE
Reception stat: WORKING
L1:038 800MIO inp1 MAIN door
30% - --|-C:NO|
Device name
Type
Device status
Pattern of the
current value and
Threshold (if applicable)
IN THE MODULE CASE
WORKING
The device
coordinate field
The Device's channels
info area
“”
Zone: 32
Assigned
zone
Zone: 32
Assigned
zone
Figure 20 Following displays of View devices on the
Loop (Detectors and Modules).