n
Disable SW Zone
The display shows the current status of the SW Zone, the
possible actions are: ENABLE or DISABLE. In this phase:
Alphanumeric keypad No function is related to Al
-
phanumeric keypad.
Cursor Keys No function is related to the UP, Down,
Right and Left Keys.
ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER key Use the ENTER key to confirm and dis
-
able the SW Zone. The User Interface moves to the
MAIN page, signalling a local programming activity fol
-
lowed by a panel reset.
4 Key - Outputs
Use the 4 key to select “Output”; after the Output has
been selected, the Output can be Disabled/Enabled
(see Figure 41).
n
Select the Output
In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to select the Output identification number.
Cursor Keys Use the UP Key to show the next type of
Outputs;
Use the Down Key to show the previous type of Out-
puts;
The type of Outputs are: SC1 Output (NACFIRE)
SC2
OC Output 1-2
No function is related to the Right and Left Key.
ESC Key Use the ESC key to cancel the operation and
to step back to previous page.
ENTER Key Use the ENTER key to confirm.
n
Disable Output
In this phase:
The display shows the current status of the Output, the
possible actions are: ENABLE or DISABLE.
Alphanumeric keypad No function is related to Al
-
phanumeric keypad.
Cursor Keys No function is related to the UP, Down,
Right and Left Keys.
ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER Key Use the ENTER Key to confirm. The User
Interface moves to the MAIN page followed by a panel
reset.
5 Key - Network
The 5 Key is used to select the Disable Network de
-
vices option; after the network device has been se
-
lected, will be disabled/enabled accordingly (see Figure
42) .
n
Select the Network device
In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to select the identification number of Network device.
+
If the number is incorrect, an error message will be
shown: WRONG VALUE
PLEASE ENTER NEW PARAMETER.
Cursor Keys Use the UP Key to show the next type of
network device ;
Use the Down Key to show the previous type of net-
work device;
The type of devices are:
- Repeater 1-4
-MFI (1-4)
-RS485NET—(local network interface)
No function is related to the Right Key;
No function is related to the Left Key.
ESC Key Use the ESC key to cancel the operation and
to return to previous page.
ENTER Key Use the ENTER key to confirm and dis
-
play the next page.
n
Disable Network device
In this phase:
The display shows the current status of the Netwok de
-
vice, the possible actions are: ENABLE or DISABLE.
Alphanumeric keypad No function is related to Al
-
phanumeric keypad.
Cursor Keys No function is related to the UP, Down,
Right and Left Key.
30 Addressable Fire Control Panels FC501
To Next Page
Loading...
