FireClass FC501-L - KEY- View Option; KEY - View Log; View Log

7 KEY- View Option
The 7 Key activates, in the ANALYZE MENU, the view
-
ing of programmed system options, see Figure 25. The
status of the DAY/NIGHT MODE options will be indi
-
cated using the following abbreviations:
-DAY: day mode
-NGT: night mode
-AUT: automatic mode.
In this phase:
Alphanumeric keypad No function is related to Al
-
phanumeric keypad.
Cursor Keys No function is related to the Up, Down,
Right and Left Key;
ESC Key Use the ESC key to cancel the operation and
to step back to previous page.
ENTER key No function is related to the ENTER key.
8 KEY - View Log
Use the 8 Key to select View LOG (see Figure 26) or di
-
rectly from the STANDBY status.
The option View Log of the menu View parameters
will allow you to view the stored events in the Log of the
fire control panel.
This Control panel can store the last 4000 occurred
events.
When the Log is full, the oldest event will be deleted, so
the newest can be stored.
+
Use the option CLEAR LOG of the Modify menu to
delete the Log events.
The following data will be stored in the LOG:
Ø
Event description;
Ø
Event number;
Ø
Description of the device (Panel or Repeater) that
generated the event;
Ø
Description of the item that generated the event;
Ø
Time and date of the event;
Ø
Address of the Item which generated the event.
View Log
From MAIN page directly, the User, without password,
can arrive to View Log see Figure 26.
The Event Class field displays the class of the event
currently displayed, the possible values are:
RESTORE
ALARM
ALARM+DLY
WARNING
FAULT
GENERIC
WALK TEST.
In this phase:
Alphanumeric keypad Used to activate the display fil
-
ters.
1: Alarm events only, 2: Delay to Alarm events only, 3:
Warning events only, 4: Walk Test events only, 5: Fault
events only, 6: Restore events only, 7: Generic events
only.
Cursor Keys Use the UP Key to select the previous
available event;
Use the Down Key to select the next available event;
Use the Right Key to view the next available data;
Use the Left Key to view the previous available data.
ESC Key Use ESC key to cancel the operation and to
step back to main page.
ENTER key No function is related to the ENTER key.
+
If the events are linked to the devices, the zone la-
bel alternates with the point label every 3 seconds.
If the zone has not been associated with the point,
only the point label will appear.
+
If the displayed events are filtered by type, “*” will
immediately begin to blink to the right of the event
number.
20 Addressable Fire Control Panel FC501
Options Lev.1: ANALYZE
Access Level
Mode Type
DAY ngt aut
DAY NIGHT MODE
^
Control panel status
If it blinks the panel
is operating normally
Master panel
Current state
DAY
Figure 25 Display: View Option.
Total :0297 status: VIEW LOG
Event :0292 RESTORE*
MS:Loop 2 det191 zone=002
08:43:11 - 01/01/07
Total stored Events
At present
stored events
This symbol: shows the presence of
following blocks to be scrolled by RIGHT key
( previous block to be scrolled by LEFT key)
1° block
Events
Type
Time and date
conncted to
the event
If it blinks the panel
is operating normally
Control panel status
If present, it shows the filtered
view by type of events
Figure 26 Display: View LOG.