FireClass FC501-L - Disabling SW Zones and Module Channels

ENTER key Use the ENTER key to confirm and dis
-
able the detector.The User Interface moves to the
MAIN page signaling a local programming activity fol
-
lowed by a panel reset.
In the case of MULTI CHANNEL MODULE, before
reaching the display 3 (see Figure 39) ENABLE/DIS
-
ABLE, a channel selected display will be shown, allow
-
ing the selection of the single channel to
ENABLE/DISABLE, display 4 (see Figure 39).
In this phase:
Alphanumeric keypad To select the desired channel
1-8.
Cursor Keys No function is related to the UP, Down,
Right and Left Key.
ESC Key Use the ESC key to cancel the operation and
to step back to previous page.
ENTER key Use the ENTER key to confirm; the User
Interface moves to the enabling/disabling page.
3 Key - SW zone
Use the 3 key to select “SW zone”; after the zone has been
selected the zone can be Disabled/Enabled (see Figure
40).
n
Select SW zone
In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to select the Zone identification number.
Cursor Keys No function is related to the UP, Down
key.
Use the Right key to select the next SW Zone.
Use the Left Key to select the previous SW Zone.
ESC Key Use the ESC key to cancel the operation and
to step back to MAIN page.
ENTER Key The ENTER key accepts the selection
and displays the next page, if the zone exists. If the
zone does not exist, an error message will be shown:
WRONG VALUE
PLEASE ENTER NEW PARAMETER.
After 5 seconds, the User interface returns to the page
of SW Zone to select.
DISABLE 29
FC501 panel lev.2 : DISABLE
FC501 panel
[L1] L2
Control panel name
Choose loop
List of the present
Loops
Loop 1
Name of the
selected Loop
FC501 panel lev.2 : DISABLE
Fc501 panel
D001 [d187] m250 801PH
Control panel name
Programming
address
List of the
present devices
Loop 1
Name of the
selected Loop
Add= > 123 <
Type of selected
device
Selected device
Symbols to show the
presence of devices
FC501 panel lev.2 : DISABLE
801PH Office zone
Disable it?
ENABLED
Present Status
Device to
Dis./Enable
Request to Enable/Disable
If it blinks the panel
is operating normally
Control panel
Status
Access level
Name of the selected
control panel
Abbr. of the selected
Loop
Name of the
selected
control panel
Control panel
Status
Access level
Control panel
Status
Access level
Control panel name
Panel name
Master control panel lev.2 : DISABLE
Office zone
5=o1 6=o2 7=o3 8=o4 410QIO inp1
1=i1 2=i2 3=i3 4=i4 loop 1
4)
Module type & channel ID
Select channel [1]
IN THE CASE OF MULTI CHANNEL MODULE
Selected channel
3)
2)
1)
Figure 39 Following Displays of Disable devices.
FC501 Panel lev.2: DISABLE
SW zone: 097
SW zone name Index of the zone
to view
FC501 Panel lev.2: DISABLE
SW zone: 097
Disable it?
ENABLED
Present Status
SW zone
to disable
Request to Enable/Disable
If it blinks the panel
is operating normally
Control Panel name
Access Level
Control panel
Status
Control Panel name
Access Level
Control panel
Status
Enter the SW Zone number
Figure 40 Display "Dis. SW. Zones".