FireClass FC501-L - Panel Configuration Modifications

2 KEY - User Password
Use the 2 key to Modify the User Password (see Figure
32).
n
Insert or Modify Password
Select the option MODIFY, the display will show Figure
32. In this phase:
Alphanumeric keypad Use the Alphanumeric keypad
to enter the last 5 digit User password.
+
To avoid the use of the same password for multiple
users, as the first digit of password, the User must
enter the number corresponding to his position,
see the following.
The first digit for the User 1: is 1
The first digit for the User 2: is 2
The first digit for the User 3: is 3
The first digit for the User 4: is 4
The first digit for the User 5: is 5
The first digit for the User 6: is 6
The first digit for the User 7: is 7
The first digit for the User 8: is 8.
Cursor Keys No function is related to the UP, Down,
Right and Left Key;
ESC Key Short press: Abort the enter password pro-
cedure and exit;
Long press: clear all the entered digits.
ENTER key Use the ENTER key to confirm the pass-
word and start the password verification process.
+
If a wrong or empty password is entered the sec-
ond page in Figure 32, will be displayed for 5 sec-
onds.
3 KEY-DAY/NIGHT
If the 3 Key is pressed, it is possible to change the con
-
trol panel operating mode: Day mode or Night mode.
The Day/Night mode will be toggled at each key 3
press.
+
The Day mode indicator light will change sta
-
tus.
n
Day/Night Mode
The control panel can operate in DAY or NIGHT Mode.
If the system is silenced during DAY Mode, SILENCE
status will be held until the system is unsilenced (i.e. un
-
til new alarms or faults occur). If the system is silenced
during NIGHT Mode, SILENCE status will be held until
the Night Mode Silence time expires. On power up (at
default) the system will set to DAY Mode. During this
operating mode, silenced alarms/faults will not be
unsilenced automatically.
+
This control panel will generate an Instant Alarm if
alarm conditions are detected during Night Mode
or if an alarm is triggered from a Callpoint.
24 Addressable Fire Control Panel FC501
System lev. 2 : MODIFY
[--------------------]
PANEL NAME FC501 Panel
Cursor (20 characters max)
^
Access level
If it blinks the panel
is operating normally
Control panel
Status
Name of Control Panel
Figure 33 Display Panel label .
Master Control Panel lev.2: MODIFY
USER#1 Enter the new password
Enter 1 as first digit
[_____]
Name of Control Panel
Field to enter the password
If it blinks the panel
is operating normally
Control panel
Status
Access Level
a)
Master Control Panel lev.2: MODIFY
USER
WRONG Password
Figure 32 Display: Modify User password.