flamco Flamcomat G4 - Appropriate Use and System Compatibility; Incoming Goods Inspection; Transportation, Storage, and Unpacking

Manual Flamcomat G4 + Flamcomat Starter G4 We reserve the right to change designs and technical specifications of our products.
9
ENG
4.5 Appropriate use
Sealed water-based heating and cooling systems in which temperature-induced changes in the volume of the
system water (the heat transferring agent) can be absorbed and the required operating pressure is governed by a
separate expansion automat.
Suitable and equipped for the operation in heat generating systems according to EN 12828, EN 12952, EN 12953.
The Principal / Operator will need to consult with a notified body on additional safety measures.
Use in similar systems (e.g. heat transfer systems for process industry or technologically conditioned heat) may
require special measures. Please note that the Flamcomat Starter must not be used in systems with mostly
stainless-steel piping and not in combination with a vacuum degasser. The complementary documents must be
studied.
4.6 Incoming goods
The items delivered must be compared against the items listed on the shipping note and inspected for
conformity. Unpacking, installation and commissioning may be started only once the product has been checked
to conform with the intended use as stated in the order process and contract. Exceeding the permissible
operating or design parameters may lead to malfunctioning, component damage and personal injury.
If not in line with conformity or if the delivery is incorrect in another way, the product must not be used.
4.7 Transportation, storage, unpacking
The equipment is delivered in packaging units in accordance with the contract specifications or the specifications
required for certain modes of transport and climate zones. These units meet at least the requirements set out in
the Flamco B.V. packaging directives. In accordance with these directives, expansion vessels must be transported
horizontally and pump units upright; each packaged on throw-away pallets. If the packaging is suitable for use
with hoisting gear, this will be indicated at the designated hoisting points.
Important note: Transport the packed goods as close as possible to the envisaged set-up location and make sure
there is a horizontal, solid surface on which the goods can stand.
Note: Take all necessary precautions to ensure that the expansion vessel cannot topple over or wobble once it
has been unpacked and removed from the pallet.
Suitable liing lugs are provided for liing and moving suspended empty vessels prior to installation. Such
devices (liing lugs) must be used in tandem; avoid side-pulling.
Caution
Heavy forkli
use fork li
1000 Ltr
>