134
Discovery, Discovery LXE, Pace Arrow, and Pace Arrow LXE
Secure the termination cap
(required by law in some
states) to termination drain.
If desired, add chemicals
to the tanks to control odor.
Follow the directions given
by the manufacturer of the
chemical.
NOTE:
Dump the black tank
before driving.
WASTE PUMP
The waste pump (Sani-Con
system) is a self-priming
macerator pump. Waste is
discharged through a 1½” outlet
hose that connects to a sewer
connection. It is recommended
to wear disposable gloves, safety
glasses and appropriate clothing
when operating the Sani-Con. The
waste pump operates on 12 Volts
DC from the house battery. The
house battery disconnect switch
must be on for the Sani-Con
system to operate.
INFORMATION:
Refer to the OEM
Sani-Con manual or visit
the website:
www.emptythetanks.com
WARNING:
Do not flush personal
hygiene products, cigarette
butts, paper towels, table
scraps, grease, any tissue
that remains in one piece
or any object that can be
considered foreign. These
objects will damage the
Sani-Con system and void
manufacturer’s warranty.
WARNING:
Never leave the Sani-Con
pump unattended while
in use. Do not allow the
pump to run dry. Damage
to the pump impeller and
Sani-Con system will result
and void manufacturer’s
warranty.
To Empty the Holding
Tanks:
Close the black tank (solid
waste) and grey tank
(liquid waste) termination
valves.
Remove the Drip Cap from
end of discharge nozzle
(see illustration).
WARNING:
Remove drip cap from
end of discharge nozzle
(see illustration). If the
Sani-Con is turned on
with drip cap in place,
turn pump off BEFORE
removing drip cap. Allow
at least 30 seconds for
pressure to dissipate before
removing drip cap.
Remove termination drain
outlet cap.
Secure Sani-Con inlet
hose to the termination
drain outlet by aligning
hose coupler tangs with
termination tabs.
Twist coupler clockwise to
lock coupler to termination
outlet.
0440223c
100220b
0440223c
To Next Page
Loading...
Need help?
General
