EasyManuals Logo

Fleetwood Pace Arrow User Manual

Fleetwood Pace Arrow
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
135
Discovery, Discovery LXE, Pace Arrow, and Pace Arrow LXE
To prevent leaks, ensure all
hose clamps are tight prior
to operation.
Insert discharge nozzle into
sewer connection (dump
station). The discharge
nozzle will t 3” and 4”
threaded and non-threaded
sewer connections. Ensure
discharge nozzle is rmly
and securely in place prior
to operation.
Verify pump operation by
opening the grey water
valve then momentarily
(less than one second)
turn on and off the Sani-
con switch. Close grey
water valve. If pump
does not operate see
Troubleshooting before
proceeding.
Open the black tank valve.
Turn on the Sani-Con
switch.
Allow the black tank to
empty.
Turn off the Sani-Con
pump when the black tank
is empty. Close the black
tank valve.
Open the grey tank valve.
Turn on the Sani-Con
pump. Allow the grey tank
to empty.
Turn off the Sani-Con
pump when the grey tank is
empty. Close the grey tank
valve.
Using the Black Tank
Flush:
NOTE:
Empty the holding tanks
before operating the black
tank flush system.
CAUTION:
Never operate the flush
system unattended.
Flooding may occur. Use
the flush system each time
the tanks are cycled to
prevent clogging of the
spray nozzle.
Connect a non-potable
water hose with pressure
regulator to a water source.
Connect the other end of
the hose to the Tank Flush
tting in water service
center.
Open the black tank valve
if closed.
Turn on the water and ush
the black tank for three
minutes. Do not leave the
system unattended during
operation.
While ushing the tank,
briey turn on the Sani-
Con pump to help ush
impeller and housing then
turn off the Sani-Con
pump.
Turn the water off after
ushing the tank. If
desired, close black tank
valve then add water to
the black tank through
the toilet then cycle the
black tank again otherwise
disconnect and stow the
non-potable hose and
pressure regulator.
Close the black tank drain
valve.
Use hand over hand
method to clear liquid from
Sani-Con discharge hose.
Secure Sani-Con drip cap
(required by law in some
states) then stow discharge
hose for travel.
If desired, add chemicals to
the holding tanks to control
odor. Follow the chemical
manufacturers directions.
Grey Water Bypass:
The grey water bypass system
allows continuous grey water ow.
The grey water uses gravity to
drain from the tank to the pump
through the bypass hose into the
sewage service. The bypass hose
“T-s” into the Sani-Con discharge
hose on the outlet side of the
macerator pump.
Troubleshooting:
The house battery
disconnect switch must be
on.
Check the 20 Amp fuse
in the House 12 Volt DC
Distribution Panel.
TOILET
Pedal Flush (If Equipped)
The toilet uses water from either
the fresh water tank or a city water
supply. The water pump must
be on or connected to city water.
The toilet ushes directly into the
sewage holding tank (black water).
040623

Table of Contents

Other manuals for Fleetwood Pace Arrow

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fleetwood Pace Arrow and is the answer not in the manual?

Fleetwood Pace Arrow Specifications

General IconGeneral
TransmissionAutomatic
Fuel TypeGasoline
Slide-outs3
Fresh Water Capacity100 gallons
Width102 inches
Sleeping Capacity6-8 people
Black Water Capacity40 gallons

Related product manuals