Fleetwood Pace Arrow User Manual

71
Discovery, Discovery LXE, Pace Arrow, and
A second coat can always be
applied if the color of the rst
coat is too light. Once the color
is blended, patch the clear nish
as described above and apply a
wipe-on nish.
COUNTERTOPS
Solid Surface
Routine Care:
The solid surface countertops
have a matte/satin nish. Soapy
water or ammonia-based cleaners
will remove most dirt and
stains from all tops and bowls.
Individual techniques may be
used to remove different stains.
Follow the recommendations
below.
NOTE:
Do not cut directly on the
solid surface.
Cleaning the Countertops:
Most dirt and stains: Use
soapy water or ammonia-based
cleaner.
Water marks: Wipe with damp
cloth and towel dry.
Difcult stains: Use Soft
Scrub
®
and a gray Scotchbrite
®
pad. If Scotchbrite is used, bufng
may be necessary to restore nish.
Disinfecting: Occasionally wipe
surface with diluted household
bleach (one part water and one
part bleach).
Repairing Cuts and Scratches
Solid surface countertops are
renewable. Use the following
instructions to repair minor cuts
and scratches:
 If scratch or imperfection
is deep, sand area with
highest grit sandpaper
to remove the blemish.
Never sand in one small
area. Feather out lightly at
each increase in sandpaper
grit to blend restoration.
 Switch from sandpaper
to 3M
™
# 35 Trizact
™
micro-abrasive disc. Apply
water while using Trizact
discs to prevent clogging.
 Work downward to #10
Trizact micro-abrasive
disc until blemish is gone.
 Buff surface with wool
pad and 3M Imperial
Compound and Finish
Material.
Preventing Heat Damage:
Hot pans and heat-generating
appliances, such as frying pans
or crock pots, can damage the
surface. To prevent heat damage,
always use a hot pad or a trivet
with rubber feet to protect the
surface.
Other Important Tips:
Avoid exposing the solid
surface to chemicals such as paint
removers or oven cleaners. If
these chemicals come in contact
with the solid surface, quickly
wash with water. Avoid contact
with nail polish or nail polish
remover. If contact is made,
quickly wash with water.
Laminate
Clean laminate countertops
with a damp cloth or sponge.
Use a spray cleaner to remove
stubborn stains. Avoid harsh
abrasives, scouring powders,
peroxides or bleaches. These
products may dull or damage the
surface. Avoid contact with dyes,
bleaches and indelible inks used
on food packages. Do not use
laminated countertops as a cutting
board. Laminated countertops are
resistant to minor heat; however,
hot pans, irons and lit cigarettes
damage the surface. Use hot pads
under pans taken directly from the
stovetop.
CAUTION:
Do not cut directly on the
laminate surface.
STAINLESS STEEL SURFACES
Stainless steel can be easily
damaged by improper cleaners.
For example: many liquid
cleansers designed to be gentle
on smooth surfaces will damage
stainless steel. Only use the
methods outlined below, and
always follow the directions that
come with the cleaner (usually
located on the bottle).
General Cleaning:
 Use warm, soapy water
and dry with a soft, clean
cloth.
For Heavy Soiling:
 Only use a stainless
steel cleaner designed
specically for appliances.
 Follow all directions from
the manufacturer of the
cleaner.

Fleetwood Pace Arrow Specifications

General

Transmission	Automatic
Fuel Type	Gasoline
Slide-outs	3
Fresh Water Capacity	100 gallons
Width	102 inches
Sleeping Capacity	6-8 people
Black Water Capacity	40 gallons