FlexGain PLEX - 1.3 Ordering Information

User’s manual FlexGain Plex, V2
Version 1.3 15 from 99
• Possibility to connect two FlexGain Plex, V2 multiplexers at a distance of 2 km
without any additional line equipment (with the help of a 1.2-mm cable);
• Simple structure of commands;
• Local (VT100) or remote (Telnet) management;
• Possibility to upgrade the software (“flash-memory”);
• In-built system of diagnostics and error statistics according to ITU-T Rec. G.826;
• Compatibility with a flexible FlexGain Plex multiplexer;
• Compatibility with a flexible NATEKS ММХ multiplexer and the family of FlexGain
and FlexDSL equipment.
1.3 Ordering information.
The table below presents ordering information for basic modules and daughter
boards of FG-Plex-, V2 multiplexers.
Table 1. Ordering information for FlexGain Plex, V2 multiplexers.
Model Description
FG-Plex-MR, V2 Basic module of the multiplexer, Mini-Rack design, installed
into a 19” cabinet.
FG-Plex-SR, V2 Basic module, Sub-Rack design, installed into a FlexGain (FG-
R-W-E) shelf, or FG-LIT and FG-COMPACT shelves.
FG-Plex-SAN, V2 Basic module, Stand Alone design for desk top applications.
FG-Plex-4FXO Daughter board for four FXO interfaces.
FG-Plex-4FXS Daughter board for four FXS interfaces.
FG-Plex-4E&M Daughter board for four voice-frequency channels.
FG-Plex-E1 Board of an additional E1 port, which is installed on FG-Plex-
XX, V2.
FG-CAB-PLEX-N35-DTE V.35 DTE cable for FG-PLEX-xx devices (DB26m - MRAC34f).
FG-CAB-PLEX-N35-DCE V.35 DCE cable for FG-PLEX-xx devices (DB26m -
MRAC34m).
To obtain more detailed information about the composition of the sets and new
models, contact the representative of the manufacturer.