FlexGain PLEX - 2.2.2.7 Network Management menu

User’s manual FlexGain Plex, V2
Version 1.3 77 from 99
<M[AIN]> command.
After the <M> command is entered the device displays exits the Configuration
Management menu and returns to the main menu.
2.2.2.7 Network Management menu.
After typing “4” in the main menu and pressing enter, the following message will be
displayed:
PLEX2_01_NM>
<H> command.
The <H> (HELP) command displays the list of command available in this sub-menu.
Enter <H> to display the list of available commands:
PLEX2_01_NM>H
ETHMODE Display/set Ethernet mode
H(HELP) Display help information
IP Display/set IP module address
MAC Display/set MAC module address
M(AIN) Return to main menu
SN Set module serial number
PLEX2_01_NM>
<M[AIN]> command.
After the <M> command is entered the device displays exits the Network
Management menu and returns to the main menu.
<ETHMODE> command.
The <ETHMODE> command sets the operation mode of the Ethernet port.
Command syntax:
<ETHMODE> [10H|10F|100H|100F|AUTO]
where
10H sets 10BASE-T half-duplex.
10F sets 10BASE-T full-duplex.
100H sets 100BASE-TX half-duplex.
100F sets 100BASE-TX full-duplex.
AUTO means automatic selection of the operation mode.
This command without any parameters displays the current operation mode of the
ETHERNET port.
To display the help information, enter <ETHMODE /H>.