User’s manual FlexGain Plex, V2
Version 1.3 47 from 99
--------------------------------------------
Command:CONFIG- display module configuration
--------------------------------------------
CONFIG :display module configuration
CONFIG PORT :display ports configuration
CONFIG STREAM :display streams configuration
--------------------------------------------
PLEX2_01_CM>
If commands <CASIN>, <CASOUT>, <SETLINE>, <DELETE>, <EVENT> are entered
without any parameters, the context help is also displayed.
Example:
PLEX2_01_CM>EVENT
---------------------------------------
Command:EVENT- system events management
---------------------------------------
LOG :display system events
CLEAR :delete all event records
---------------------------------------
PLEX2_01_CM>
Note: in the current software version, only parameters PCM1 and PCM2 can be used for
commands <CASIN>, <CASOUT>, <FRAME>, <RESETG826>, <LDL>, <RDL>,
<PCMLED>, <CONNECT>, <MUX>, <FTSPAD>, <IDLECAS>, <MOVECAS>,
<SETCLOCK> (the use of the PCM3 parameter is prohibited).
2.2.2.4 Performance management menu.
After typing “1” in the main menu and pressing<enter>, the following message will be
displayed:
PLEX2_01_PM>
<H> command.
The <H> command (<HELP>) displays the list of commands available in this sub-
menu. Type <H> to display the list of available commands:
PLEX2_01_PM>H
CASIN PCM30 incoming channel signaling snapshot
CASOUT PCM30 outgoing channel signaling snapshot
G826 Display G.826 parameter
FRAME Display PCM stream RX and TX frames snapshot
H(HELP) Display help information
M(AIN) Return to main menu
RESETG826 Reset G.826 error parameters
To Next Page
Loading...
