FlexGain PLEX - 2.2.2.6 Configuration Management menu

User’s manual FlexGain Plex, V2
Version 1.3 60 from 99
<H> command.
The <H> (HELP) command displays the list of command available in this sub-menu.
2.2.2.6 Configuration Management menu.
After typing “3” in the main menu and pressing enter, the following message will be
displayed:
PLEX2_01_CM>
<H> command.
The <H> (HELP) command displays the list of command available in this sub-menu.
Enter <H> to display the list of available commands:
PLEX2_01_CM>H
BAUDRATE Display/set console COM channel baudrate
CONFIG Display current system configuration
CONNECT Assign time slot(s) to physical or logical module device
DEFAULT Set default module configuration
DELETE Disconnect physical or logical module device from timeslot(s)
EVENT Display/clear module events log
FTSPAD Display/set PCM stream unused timeslots padding value
H(HELP) Display help information
IDLECAS Set CAS bits for unused timeslot(s)
M(AIN) Return to main menu
MOVECAS Change the signaling timeslot number
MUX Set cross-stream multiplexing point(band)
NAME Display/set module identifier
PCMMODE Select PCM-mode
PORT Set ports environment
RESET Module restart
SAVE Store module's co’figuration in flashROM
SETCLOCK Set source of synchronization priority
SIGBYTE Set MEGATRANS signaling values
SIGNALING Set signaling type for signaling modules
UPDATE Update module software
PLEX2_01_CM>
<BAUDRATE> command.
The <BAUDRATE> command changes the operation rate (baud rate) of the
multiplexer over the serial RS-232 port. To operate the device at a new speed, the reset is
not reqired.
Command syntax:
<BAUDRATE> [SPEED]
where
SPEED is the baud rate (operation rate) of RS-232, which can take the following
values 9600, 19200, 38400, 57600 and 115200 bit/sec.