FlexGain PLEX - Page 59

User’s manual FlexGain Plex, V2
Version 1.3 59 from 99
The <V35CLKTX> command without any parameters displays the current mode of
the transmitter of the V.35 interface.
To display the help information, enter <V35CLKTX /H>.
Example:
PLEX2_01_FMM>V35CLKTX NORMAL
PLEX2_01_FMM>V35CLKTX
V35 stream transmit clock polarity:NORMAL
<V35CLKRX> command.
This command is similar to the <V35CLKTX> command, but it sets the clock mode
from the receiver of the V.35 interface.
Command syntax:
<V35CLKRX> [NORMAL | INVERS]
where
NORMAL sets synchronization from the leading edge of the clock pulse;
INVERS sets synchronization from the trailing edge of the clock pulse.
The <V35CLKRX> command without any parameters displays the current mode of
the receiver of the V.35 interface.
To display the help information, enter <V35CLKRX /H>
Example:
PLEX2_01_FMM>V35CLKRX NORMAL
PLEX2_01_FMM>V35CLKRX
V35 stream receive clock polarity:NORMAL
<VERSION> command.
The <VERSION> command displays the hardware version of the printed circuit
board and the downloaded software version of the device.
To display the help information, enter <VERSION /H>
Example:
PLEX2_06_FMM>VERSION
Module software version:1.00. Release at 18.04.05.
Module hardware version:1.02. Release at 17.01.05.
PLEX2_06_FMM>
<M[AIN]> command.
After the <M> command is entered the device displays exits the Fault and
Maintenance Management menu and returns to the main menu.