User’s manual FlexGain Plex, V2
Version 1.3 78 from 99
Example:
PLEX2_01_NM>ETHMODE 10H
PLEX2_01_NM>ETHMODE
Current Ethernet mode is 10BASE-T half duplex.
PHY controller in manual mode.
<IP> command.
The <IP> command displays and configures the IP address of the device. The
command without any parameters displays the IP address of the device. The subnetwork
mask is not configured. When this command is used with parameters, the IP address of the
device can be changed. If the new IP address was not saved within five minutes after it
was configured, FlexGain Plex, V2 device returns to the previous IP address.
Command syntax:
<IP> [x.x.x.x]
where х.х.х.х is the IP address of the device.
To display the help information, enter <IP /H>
Example:
PLEX2_01_NM>IP 10.3.3.5
New module control IP address is 010.003.003.005
PLEX2_01_NM>IP
Module IP address is 010.003.003.005
Note: the IP address is configured according to the parameters of the local network. The
network should not contain two devices with equal IP addresses.
<MAC> command.
The <MAC> displays the configured MAC address of the device. This command is
used without any parameters.
To display the help information, enter <MAC /H>
Example:
PLEX2_01_NM>MAC
Module MAC address is 00.0F.D9.00.10.CB
<SN> command.
The <SN> command displays the serial number of the multiplexer. This command is
used without any parameters.
To display the help information, enter <SN /H>
To Next Page
Loading...
