Flexim FLUXUS WD200 - Page 94

FLUXUS WD100, WD200 A Menu Structure
94 UMFLUXUS_F5WDV1-1EN, 2016-04-08
error message that there is a problem with the serial transmission of data
display of the data transmission progress
Delete Meas.Val.
selection of the displays for the deleting of stored measured values
confirmation for the deleting of measured values
This display will only be indicated if measured values are stored in the data log-
ger.
Program Code
selection of the displays for the input of a program code
defining a program code
input of the break code (= program code)
input of the access code (= the first three digits of the program code)
After the Input of HotCode 071001
input of the lower limit of the inner pipe diameter for the displayed transducer
type
range: 3...63 mm
x
INIT-
resistant
SERIAL ERROR !
Print Meas.Val.

................
Special Funct. ↕
Delete Meas.Val.
Really Delete?
no >YES<
Special Funct. ↕
set program code
set program code
------
INPUT BREAK_CODE
CODE: 000000
INP. ACCESS CODE
CODE: 000000
DNmin Q-Sensor
15 mm