Name: FLIR T1020
Brand: FLIR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Handling the camera13

Note

• Do not touch the lens surface when you adjust the infrared camera focus manually. If

this happens, clean the lens according to the instructions in 31.2 Infrared lens, page

200.

• The focus ring can be rotated infinitely, but only a certain amount of rotation is needed

when focusing.

• The response of the focus mechanism is progressive, meaning that a faster rotation

of the focus ring gives a disproportional higher speed of focus change. This allows for

both fine adjustment with a relatively large (but slow) rotation and rapid change with a

smaller (but faster) rotation. Furthermore, for a very slow rotation, the lens moves in

very small, discrete steps (which you can hear), allowing for a controlled fine adjust-

ment of the focus.

13.7 Autofocusing the infrared camera

13.7.1 General

The infrared camera can be configured to autofocus when you push the Save button

half-way down.

13.7.2 Figure

13.7.3 Procedure

Follow this procedure:

1. To enable the autofocus function of the Save button, select

(Settings) > Save op-

tions & storage > Save button half-press = Autofocus.

2. To autofocus, push the Save button half-way down.

Note You can also assign the autofocus function to the programmable button

or .

For more information, see section 13.11 Assigning functions to the programmable but-

tons, page 33..

13.8 Continuous autofocus

13.8.1 General

The infrared camera can be set up to perform continuous autofocusing.

#T559954; r. AP/42311/42335; en-US

Other manuals for FLIR T1020

Questions and Answers:

Need help?

Do you have a question about the FLIR T1020 and is the answer not in the manual?

General