Name: FLIR T1020
Brand: FLIR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Pairing Bluetooth devices

23.1 General

Before you can use a Bluetooth device with the camera, you need to pair the devices.

23.2 Procedure

Follow this procedure:

1. Push the joystick to display the menu system.

2. Use the joystick to go to

(Settings).

3. Push the joystick to display the Settings menu.

4. Select Device settings and push the joystick.

5. Depending on the camera configuration, select Wireless & geolocation, Wireless, or

Geolocation and push the joystick.

6. Select Bluetooth and push the joystick.

7. If the Bluetooth check box is unchecked, push the joystick to activate Bluetooth.

Note You also need to ensure that the external Bluetooth device is in visible mode.

8. Select Available devices and push the joystick.

9. Wait until a list of available devices is displayed. This will take about 15 seconds.

10. When a Bluetooth device is found, select the device to add it, and begin the pairing

procedure. The device is then ready to be used.

Note

• Only Bluetooth-enabled headsets will appear in the list of available devices.

• You can add several devices.

• You can remove a device by selecting the device and then selecting Unpair device.

• After adding a Bluetooth-enabled headset, it is ready to be used for adding voice

annotations.

#T559954; r. AP/42311/42335; en-US

Other manuals for FLIR T1020

Questions and Answers:

Need help?

Do you have a question about the FLIR T1020 and is the answer not in the manual?

General