5700A/5720A Series II Calibrator
Service Manual
2-92
is configured the same as for 220V ac operation, except that the input is the square-wave
signal HVCL from the High Voltage Control assembly, rather than OSC OUT HI,
through relays K13B and K10A.
2-153. 220V DC Internal Calibration Network
The 220V dc internal calibration network determines the exact gains and offsets of the
power amplifier. This circuit uses part of the resistor network HR8 as the input
attenuator, and uses op amp U9, and zener diodes VR57 and VR58. Relay K4 connects
the output of this circuit to the RCL line.
Zener diodes VR57 and VR58 reduce the power supplies for chopper-stabilized amplifier
U9, which is used as a voltage follower.
2-154. PA Calibration
The following paragraphs describe how the Power Amplifier assembly is calibrated
during the internal portion of calibration, or calibration check. This process calibrate the
offset, gain, and frequency characteristics of the Power Amplifier.
The instrument measures the offset of the main amplifier (220V range). The DAC output
is amplified by the Power Amplifier, which is configured for the dc 220V range, and its
output connected to the internal cal zero amplifier located on the Switch Matrix
assembly. Output of this internal cal zero amplifier is channeled to the DAC's adc
amplifier circuit by the RCL line. Input of the internal cal zero amplifier is first connected
to R COM where a checkpoint reading is taken by the DAC's adc circuit. The output of
the Power Amplifier is then connected to the input of the internal cal zero amplifier and
the DAC output is adjusted to the checkpoint reading out of the zero amplifier. This
adjusted DAC output is a measure of the offset of the Power Amplifier. Also, refer to the
Switch Matrix theory of operation.
The 175 kΩ/25 kΩ (internal cal) resistor network located on HR8 is calibrated next (see
Figure 2-23). First the offset of the 220V dc internal cal amplifier is measured. This is
done by connecting pin 6 of 175 kΩ/25 kΩ resistor network to RCOM by relay K1, and
pin 7 to ACOM by U5C and relay K3. ACOM is connected to RCOM through 051
during this step. Output of this internal cal amplifier is connected to the RCL line by
relay K4, where it is measured by the adc circuit on the DAC assembly. As before, the
DAC's output needed to obtain the checkpoint for this step represents the offset of the
internal calibration amplifier.
Resistor network attenuation is calibrated next. Components U5A, U5D and K3 connect
BSRF13 and BRF13 to the 175 kΩ end, while K1 connects R COM to the 25 kΩ end of
the resistor network. The resulting 1.625V at the output is connected to the RCL line by
relay K4, where it is connected to the +input of the adc amplifier circuit on the DAC
assembly. The DAC output is connected to the adc circuit -input, and adjusted until the
checkpoint reading is obtained. The exact value of this voltage is now known, so the
system software computes the exact attenuator ratio from this known voltage, BSRF13
value, and the previous offset measurement.
To Next Page
Loading...
Need help?
General
