Fluke 729 - Page 17

Automatic Pressure Calibrator
Buttons
11
Table 3. Buttons
Number Description Number Description
A
Power button. Push to turn on or turn off
the Product.
F
Display brightness button. Push to change the
display brightness from dim to bright and back again.
B
BACK button. Push to move to the
previous user interface (UI) screen. When
navigating through the screens, BACK can
move out of most screens and with
repeated pushes, can take you all the way
to the startup screen.
G
Numeric keypad. Used when a numeric entry is
necessary.
C
F1-F4 softkeys. Performs the specified
function of the label above each softkey on
the display. These labels change
throughout the UI.
H
ENTER button. Push to make a selection on the UI.
Only ENTER confirms numbers and characters.
Confirm all editable items with ENTER.
D
Arrow buttons. Push to move the display
cursor left, right, up, or down. Cursor
highlights in yellow over the selection.
I
CLEAR (ZERO) button. Push to clear highlighted
entry. When PI/PV/IP/SWT starts, push to zero the
pressure reading.
E
SELECT button. Push to make a selection
on the UI. Cannot confirm number or
character choices with this button (push
ENTER).
J
mA button. Push to select mA measure function.