Fluke 729 - Page 18

729/729FC
Users Manual
12
fTable 3. Buttons (cont.)
Number Description Number Description
K
VDC button. Push to select the measure dc
voltage function.
O
SOURCE PRESSURE button. Use this function
to output (source) a target pressure from the
Product. Use the arrows to select the Setpoint
field and enter the values with the number
buttons.
L
SETUP button. Push to enter the Setup menu
to change operating parameters. See Setup
Menu.
P
MEASURE PRESSURE button. Use this function
for pressure measurement mode.
M
TASKS button. Push to enter the Tasks menu.
See TASKS Menu.
Q
HART button. Push to enter HART
communication mode.
N
VENT button. Push to release pressure at the
internal pressure port. VENTING shows on the
display as the Product vents. VENTED shows
after venting is complete.
R
HOLD button. Push to freeze the reading on the
display. Push it a second time to release the hold
on the display. Push and hold to capture the
screen and save into memory.