Index
(continued)
5
—S—
Safety
operational information, 2-1
standards, 8-24
Saving Autotest results, 3-26
quick start, 2-11
Scanning, 4-2
Self test
failure, 8-3
how to run, 2-29
Self-calibration, 6-1
Serial port
cable for printer interface, 5-2
configuring for printing, 5-2
connection for printing, 5-3
error, printing, 5-5
interface description, 8-20
problems with PC communications, B-6
Setup
configuring the test tool, 2-30
downloading from a PC, 2-30
list of settings, 2-26
quick setup, 2-8
Shield continuity test, enabling, 2-32
Short,wire map display, 3-8
Single test
tests for twisted pair, 4-1
Single Test
tests for coaxial cable, 4-16
Smart remote. See Remote
Softkeys description, 2-18
Software upgrades, B-18
Special functions, list of functions, 2-27
Split pair
explanation of split pair, 7-16
Split pair,wire map display, 3-8
Standards
CSA, 8-24
safety, 8-24
test, 8-11
Storage, 8-2
Store plot data, B-9
selecting, quick start, 2-8
Strap, 2-23
Switch modes, 2-23
—T—
Talk mode, 2-14
Terminator
connection during length test, 3-25
connection during resistance test, 3-25
effects on HDTDR test, 4-10
Test standard
descriptions of standards, 2-24
selecting, 2-32
selecting, quick start, 2-8
Time, 2-39
Tone generator, 4-26
Traffic monitor, 4-19
Troubleshooting
finding cable faults, 7-27
troubleshooting the test tool, 8-3
—U—
Using this manual, 1-6
—V—
Version
hardware, 2-28
software, 2-28
test standards, 2-28
Viewing saved reports, 5-6
Viewing saved results
quick start, 2-11
Voice communication, 2-14
—W—
Warning messages
battery voltage messages, 2-42
characteristic impedance warning, 3-10
excessive noise detected, 2-30
excessive voltage detected, 2-29
printed reports, 3-30
test result memory is now full, 3-29
test summary result, 3-10
the previous test results have not been
saved, 3-2
unable to save test results, 3-29
To Next Page
Loading...
