Initializing sensor
The hint "Communication error" [1] suggests that the sensor has not been initialized although
the laser beam may have been correctly adjusted.
Tap the detector and sensor area [2] to access the menu item 'Sensor list'.
Tap menu item 'Sensor list' [1] to view scanned sensors. The hint 'Scanning for sensor(s)' [2]
appears during the scanning process. As soon as the sensor is detected, it is listed down and a
green bold dot [3] appears next to the detected sensor.
Initialize the sensor by tapping the listed sensor. A bold blue dot [1] signifies that the sensor is
initialized.
SHAFTALIGNtouch 55
On-board help
To Next Page
Loading...