DSP-4000 Series
Users Manual
5-2
Note for Models DSP-4100/4300
You cannot view results saved on a memory card if they were created
using a different test standards version than is present in the test
tool. To view these results, use LinkWare
software to upload them
to a PC.
To change the cable identification, press the @ Rename Report softkey
that appears after you press View Result twice. Use the softkeys to edit the
cable identification. Press S when you are done.
To delete all of the Autotest reports stored in memory, select Delete All
Test Reports from the main SPECIAL FUNCTIONS menu.
Note for Model DSP-4300
When a memory card is present, the VIEW/DELETE TEST
REPORTS function always shows the reports saved on the card.
When a card is not present, the test tool shows the reports saved in
internal memory.
Printing Test Reports
This section describes how to send reports directly to a printer. If you want to send
reports to a computer, use the LinkWare software provided with the test tool.
See “Getting Started” under Help on the LinkWare toolbar for details.
The PRINT mode on the rotary switch lets you send saved Autotest reports or
report summaries to a serial printer or a PC through the test tool’s EIA-232C serial
port. You can also edit the header, operator name, and site name that appear at the
top of reports.
To Next Page
Loading...
Need help?
General
