Getting Started
Quick Start
2
2-5
Using the Link Interface Adapters
The link interface adapters provide the correct connectors and interface circuitry
for testing different types of LAN cable. The adapters also allow for upgrades
when new types of cable are developed. See “Link Interface Adapter Features” in
this chapter for more details.
If your test tool includes the DSP-LIA101 Permanent Link Adapters, see
“Permanent Link Interface Adapters” in this chapter for important handling
information.
Optional link interface adapters that provide additional functions are available
from your Fluke Networks dealer. Visit the Fluke Networks website at
www.flukenetworks.com for the most recent information on optional adapters.
Figure 2-1 shows how to attach a link interface adapter. Self-calibration is not
required when you change adapters. The test tool displays a message if you try to
run a test that is not supported by the attached link interface adapter. Refer to
Appendix A for a list of tests supported by the standard link interface adapters.
The LIA Status selection on the SPECIAL FUNCTIONS menu reports the type of
link interface adapter attached to the main and remote units. The status display
also shows how many Autotests have been run with each adapter.
To Next Page
Loading...
Need help?
General
