3-1
Chapter 3
Autotest
Chapter 3 provides the following information:
• Instructions and test result descriptions for an Autotest on twisted pair cabling.
• Instructions and test result descriptions for an Autotest on coaxial cabling.
• Instructions for saving Autotest results.
Autotest Softkeys
Note
New features may be available with software upgrades. Visit the
Fluke Networks website at www.flukenetworks.com or contact your
Fluke Networks representative for information on upgrades.
The following softkey functions are active on various Autotest screens.
! or @ View Result: ! shows the results of the last Autotest run.
@ shows detailed test results regarding the highlighted cable pair or pairs.
# View Plot: Press to see a frequency response plot of the test results. Plot
data is available for the NEXT, ELFEXT, attenuation, ACR, RL, PSNEXT,
PSELFEXT, and PSACR tests.
@ Next Pair, @ Next Pairs: Press to see the detailed results or
the plot for the next cable pair or pairs tested.
$ or @ Memory: Press to see the number of Autotests stored and the
number of remaining memory location. If a cable ID list function, such as auto
sequence, is enabled, the display also shows the cable ID range, the total number
of IDs, and the number of IDs available.
To Next Page
Loading...
Need help?
General
