DSP-4000 Series
Users Manual
2-40
Viewing the Cable ID Configuration and Memory Status
To see the cable ID configuration (if one is enabled), the number of Autotests
saved in memory, and the available memory, press the Memory softkey that
appears on several of the Autotest displays.
On a DSP-4100 or DSP-4300 you can see the memory card status by selecting
Memory Card Configuration in the SPECIAL FUNCTIONS mode.
Model DSP-4300 shows the status of the internal memory if no memory card is
present.
Storing Plot Data with Saved Autotest Results (DSP-4100/4300)
When STORE PLOT DATA is enabled, saved Autotest results include plot data
from tests such as the attenuation and NEXT tests. HDTDX and HDTDR plots are
also saved with the Autotest results. Saving the plot data lets you include plots on
test reports uploaded to a PC and printed with LinkWare Software. The
DSP-4100 and DSP-4300 can save the results of at least 250 Autotests on a 16 MB
memory card when plot data is included. More results can be saved if plot data is
not included.
The DSP-4300 can save at least 250 Autotest results with plot data in internal
memory when a memory card is absent.
Enable or disable this setting as follows:
1. Turn the rotary switch to SETUP.
2. Use $ Page Down and D to find and highlight the store plot data
setting.
3. Press ! Choice.
4. Use D U to highlight the desired setting; then press E.
Selecting a Length Unit
The test tool displays length measurements in meters or feet.
To change the unit of measurement, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press $ Page Down until you see the length units setting.
3. Press ! Choice.
4. Use D U to highlight the desired unit.
5. Press E to accept the highlighted unit.
To Next Page
Loading...
Need help?
General
