95
8.7 Camera Alignment Issue
Run camera calibration in software: Beam Studio
> Menu > Machines > Choose Machine > Calibrate
Camera. Make sure the height of the laser head is
adjusted to the right focus.
Compare the red-dotted-line square with the
actual square engraved, manually adjust values to
make the 2 squares overlapping.
8.8 Camera Preview Speed Too Slow
The preview results are formed by multiple snapshots
put together, if the loading speed is too slow,
improving the internet connection might help.
Go to software: Menu > Machines > Test Network
Settings.
Fill in the Target device IP Address column with
the machine IP address.
Press Start and the test will start running.
If the average response time is over 100ms, try
reducing the distance between the machine and
the router or mobile hotspot, or change to a wired
connection.
To Next Page
Loading...
Need help?
General
