60
7.6 Optical Path Adjustment
If the workpiece cannot be cut through by the preset
parameters or the power output seems to vary a lot
on each corner of the working area, the optical path
might have got misaligned and need readjustment.
Please yry the steps below.
Tools
Accessory Box:
little wrench
③
double-sided tape
Prepare On Your Own:
①
2.5mm Allen key
When pressing "Laser Pulse", please keep the
door shut so the laser will not be disabled by the door
interlock protection.
If you hear a loud cracking sound, stop operating
and shut down the power immediately. Contact FLUX
Support.
To Next Page
Loading...
