96
8.9 Camera Preview Doesn’t Work
If camera preview can’t be activated, please try the
following:
Restart the machine and press Action and wait for
the laser head to go to home position.
Use the arrow keys or manually move the laser
head to the center of the bed.
Press Snapshot, if the image is shown, it means
the camera is functioning. Please refer to 9.8 Camera
Preview Speed Is Too Slow (p.95).
If you see a question mark icon, it means the
camera is not functioning. Please contact FLUX
Support.
8.10 Connection Issue
8.10.1 No Wi-Fi Found
Make sure the Wi-Fi dongle is fully plugged in.
If you don’t see the MAC Address of wireless
network on the touch panel, please contact FLUX
Support.
The Wi-Fi channel should be 2.4Ghz (5Ghz is not
supported).
To Next Page
Loading...
