Datalogger
1. Date and time: Date and time referred to the cursor position
(5).
NOTE: the date and time indications is read from an external
GPS, if connected; if no GPS is connected to the Vigilus,
these indications will not be available.
2. Engine hours: Total accumulated engine hourmeter referred
to the cursor position (5).
3. Progress indicator: as you scroll through the flight, the
progress indicator let’s you see at which point of the entire flight
you are pointing with the cursor.
4. Graphics and numerics data: 3 graphics per page, divided in
more pages. For each measurement you can also see if, at the
cursor position, the measurement was in an alarm condition: if
after the numerical indication there is the “L” letter it means that
the measurement was under the low threshold; if after the
numerical indication there is the “H” letter it means that the
measurement was over the high threshold; if after the numerical
indication there is the “P” letter it means that there was a probe
error (probe disconnected for example).
5. Cursor: The cursor permits to analyze the flight throughout its
duration. All numerical values are relative to the actual position
of the cursor (rotate the knob to move the cursor).
6. Knob and pushbutton functions:
- Press the left button (Back) to go back to the datalogger menu
- Rotate the knob to move the cursor through the flight or click
the knob to switch to the “Scroll item” mode:
To Next Page
Loading...