Fortinet FortiFone - Network Configuration; Network Mode Settings

Personalizing your Phone Page 7 FortiFone™ User Guide for FON-260i
Configuration Overview
The phone supports the access and configuration of many parameters directly from the
Telephone User Interface. To access the Configuration menu, press the button while the
phone is not in use.
The configuration menu consists of several sub menus as listed below:
1. Network Configuration
2. SIP Configuration
3. Phone Settings
4. Call Preferences
5. Directory
6. Set to Defaults
7. Lock/Unlock Config
8. Information
9. Reboot Phone
Network Configuration
The Network Configuration menu allows configuration of the network parameters for the phone.
Network Mode
The phone is capable of obtaining all of its IP configuration data from a DHCP server. When a
DHCP server is not available, static address parameters can be used. Selecting Static requires
the manual entry of other several network parameters including:
• IP address of the phone
• Default gateway IP address
• Subnet mask
• DNS address
To set the Network Mode:
• Press the button, select 1. Network Configuration then press the OK button.
• Select 1. Network Mode then press the OK button.
• Select the Network Mode then press the OK button to save your selection.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
After any network configuration changes, you will receive a reboot notice. Changing network
parameters requires a reboot of the phone before the new values can be used. Networking
parameters can only be changed when the network mode is set to Static.