Personalizing your Phone Page 18 FortiFone™ User Guide for FON-260i
Registration Expiry
To ensure a regular connection, the phone periodically re-registers with the proxy or SIP server.
Unless defined by the host server during registration, the Register Expires timer determines the
interval between registration attempts and can be set from 0 to 86400 seconds. The default is
3600 seconds (1 hour).
To modify the Registration Expires timer:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 9. Register Expires then press the OK button.
• Input the registration expiration time using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Voicemail URL
The Voicemail URL is used to access the voicemail of a host service or PBX. If not configured by
the host service or PBX, then it should be configured accordingly.
To assign the Voicemail URL:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 10. Voicemail URL then press the OK button.
• Input the Voicemail URL using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Domain
The Domain specifies the domain for SIP service when the provider desires to use a specific SIP
domain for the phone.
To assign the Domain:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 11. Domain then press the OK button.
• Input the Domain name using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Changing the Registration Expiry requires a reboot of the IP phone. When you exit the menu,
you will receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to
utilize the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
Changing the Domain requires a reboot of the IP phone. When you exit the menu, you will
receive a reboot notice. The IP phone must reboot to utilize the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
To Next Page
Loading...
