Personalizing your Phone Page 14 FortiFone™ User Guide for FON-260i
Authentication User Name
A user name is required to authenticate a line.
To assign the Authentication User Name:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 5. Auth. Username then press the OK button.
• Input the Authentication User Name, as is specified in the SIP server, using the dial pad and
press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Authentication Password
Authentication of the line with the SIP call server requires an Authentication Password in
conjunction with the User Name.
To assign the Authentication Password:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 6. Auth. Password then press the OK button.
• Input the Authentication Password using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Registration Status
The status of the line registration with the SIP call server can be viewed from this menu. The
status is displayed as OK, NOK (Not registered) or undefined (not assigned).
To view the Registration status for a line:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 7. Reg. Status to view the status.
• The status is actually shown next to the menu title.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Changing the Authentication User Name requires a reboot of the phone. When you exit the
menu, you will receive a reboot notice. Press the OK button to reboot. The IP phone must
reboot to utilize the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
Changing the Authentication Password requires a reboot of the phone. When you exit the
menu, you will receive a reboot notice. Press the OK button to reboot. The IP phone must
reboot to utilize the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
To Next Page
Loading...
