Fortinet FortiFone - SIP Configuration; SIP Line Configuration; SIP Server Address Setup; Proxy Port Setup

Personalizing your Phone Page 12 FortiFone™ User Guide for FON-260i
SIP Configuration
The SIP Configuration section contains parameters related to SIP accounts, and other
parameters that allow the phone to register.
SIP Configuration, Line Configuration
Assign parameters in this section for each SIP line.
SIP Server Address
The SIP Server Address is the IP address or FQDN of the SIP server or PBX.
To assign the SIP Server address:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 1. SIP Server Address then press the OK button.
• Input the SIP Server Address or FQDN using the dial pad and press the OK button to save
your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Proxy Port
The Proxy Port defines the UDP port number employed for SIP signaling transport. In common
practice, the port number 5060 is used.
To change the Proxy Port number:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 1. Line Configuration then press the OK button.
• Select 2. Proxy Port then press the OK button.
• Input the Proxy Port number using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Changing the SIP Server Address requires a reboot of the phone. When you exit the menu, you
will receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize
the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
Changing the Proxy Port requires a reboot of the phone. When you exit the menu, you will
receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize the
new values entered.