Fortinet FortiFone - VLAN Priority and ID for LAN Port

Personalizing your Phone Page 10 FortiFone™ User Guide for FON-260i
VLAN Priority (LAN)
The VLAN Priority (LAN) establishes the priority for Ethernet frames from the LAN port including
signaling and voice packets. Setting the VLAN ID to zero (0) disables VLAN framing and the IP
phone uses only standard Ethernet frames.
To assign VLAN Priority for the LAN (voice) port:
• Press the button, select 1. Network Configuration then press the OK button.
• Select 8. VLAN Settings then press the OK button.
• Select 1. VLAN Priority (LAN) then press the OK button.
• Input the VLAN Priority for the LAN port using the dial pad and press the OK button to save
your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
VLAN ID (LAN)
The VLAN ID (LAN) assigns the identification for Ethernet frames for the phone LAN port
including signaling and voice payloads. Setting the VLAN ID to zero (0) disables the VLAN
framing and the IP phone and uses only standard Ethernet frames.
To assign the VLAN ID for the LAN (voice) port:
• Press the button, select 1. Network Configuration then press the OK button.
• Select 8. VLAN Settings then press the OK button.
• Select 2. VLAN ID (LAN) then press the OK button.
• Input the VLAN ID for the LAN port using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Changing the VLAN Priority requires a reboot of the IP phone. When you exitthe menu, you will
receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize the
new values entered.
The recommended value for VLAN Priority (LAN) port is 5.
To disable VLANs, assign the VLAN ID as zero (0).
Changing the VLAN ID requires a reboot of the phone. When you exit the menu, you will receive
a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize the new
values entered.
To disable VLANs, assign the VLAN ID as zero (0).