Fortinet FortiFone - SIP General Parameters; Proxy Server Address Setup; Proxy Server Port Setup

Personalizing your Phone Page 15 FortiFone™ User Guide for FON-260i
SIP Configuration, General Parameters
Parameters in this section are required for the overall SIP operation of the phone.
Outbound Proxy Address
If required, an Outbound Proxy Address can be defined so that the phone sends all SIP
requests to the proxy instead of the SIP server configured in the section “SIP Server Address”
on page 12. The address can be an IP address or FQDN.
To assign an Outbound Proxy Address:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 2. Outbound Proxy Addr. then press the OK button.
• Input the Outbound Proxy Address using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Outbound Proxy Port
With the Outbound Proxy Server defined, the associated port must be defined as the Outbound
Proxy Port. All SIP requests are sent to the assigned port instead of the proxy port configured in
the section “Proxy Port” on page 12.
• To assign the Outbound Proxy Port:
• Press the button, select 2. SIP Configuration then press the OK button.
• Select 3. Outbound Proxy Port then press the OK button.
• Input the Outbound Proxy Port using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the button to exit the configuration session.
Changing the Outbound Proxy Address requires a reboot of the phone. When you exit the
menu, you will receive a reboot notice. Press the OK button to reboot. The IP phone must
reboot to utilize the new values entered.
To enter alphanumeric characters select the button. Refer to “Appendix B. Character Table
for Dial Pad Mode” on page 61 for the character mapping of dial pad digits.
Changing the Outbound Proxy Port requires a reboot of the IP phone. When you exit the menu,
you will receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to
utilize the new values entered.